RF FAQ
The channel depends on the software version loaded into the unit: Software Version / Mode / Port 2.2.5 and below / Legacy HD Primary / 10,000 ...
Tue, 8 Oct, 2019 at 11:40 AM
Install the Power Supply making sure to remove the Tufex air-dam that would have been installed above the power supply #3 position and then install jumper P...
Tue, 8 Oct, 2019 at 11:42 AM
The nominal power is 100W out of the IPA (STXe 500 Exciter), this value is hard-coded in the software and can't be adjusted. If there are Power Supp...
Wed, 22 Feb, 2023 at 6:45 AM
The AM transmitter will be muted with no RF output. The AM 500A and 1A transmitters only have one power supply; most likely it will need to be repaired/repl...
Tue, 8 Oct, 2019 at 10:16 AM
•PA Modules –4 operational = 11 kW (Normal Operation) –3 operational = 7.5 kW –2 operational = 5 kW –Less than 2 = no output power •Power Supplies ...
Tue, 8 Oct, 2019 at 11:44 AM
PCB, ASSY, STX INVERTER I/O BOARD I/O Inverter Board. Input/Output Inverter board. Allows the transmitter Inputs to be controlled by positive logic. Nee...
Wed, 3 Jul, 2024 at 10:07 AM
FXi 60 = 350 watts, FXi 250 = 850 watts.
Tue, 8 Oct, 2019 at 12:51 PM
The ASi 10, FSi 10, and the XPi 10 all draw basically the same amount of current; therefore for planning purposes you can use 165 Watts as an adequate basel...
Tue, 8 Oct, 2019 at 12:53 PM
The standard internal web page uses port 80. Two ports need to be opened for the RGUI to properly function: TCP: 0xBE00 (48640) UDP: 0xBE01 (48641)
Tue, 8 Oct, 2019 at 12:55 PM
The most probable cause is loss of the controller power supply P/N 540-0006. This can be verified by opening the door to the control board and checking to s...
Tue, 8 Oct, 2019 at 12:57 PM